rel_shw

Is it possible to melt snow off of my collectors?

Yes it is. Depending on your type of collector, you can program your controller to manually activate the circulator which will bring heat from your storage vessel and into the collectors, which will radiate that heat back out thus melting the snow. This method only works for FLAT PLATES however...

Read more...

How do I know if my system is performing the way it should be?

First of all, your system performance will be measured by BTU'S produced, NOT by temperature achieved. The simplest way to accomplish this is by following this method: 1- Record your solar tank temperature first thing in the morning, before the solar pump turns on. 2- be sure that no one uses hot...

Read more...

How do I size a solar hot water system for my household?

Typically, an american average consumption of 20 gallons of hot water per day per person can be used to size systems. There are some variations in that however so we need to be careful about just using rules of thumb. For most of the Sunmaxx TitanPower Flat plates and Thermopower...

Read more...

How well will my collectors perform if they are not positioned perfectly?

Fortunately, solar thermal collectors are not nearly as sensitive to light conditions as PV collectors. As for performance, you have roughly a 60 degree window of opportunity to mount the collectors toward south before you begin losing a small bit of total production. In other words, your house can be...

Read more...

Can I tie a solar thermal system into my existing system?

Yes, you sure can. There are very few systems in the US that will not accept a solar thermal upgrade, The only exception would be a steam system. Whether you have forced hot air, boiler with baseboard, sub-floor radiant, in-floor radiant or wall heaters you can very easily integrate a...

Read more...

Simulating Performance of Solar Thermal Systems

Solar thermal systems will behave differently depending on a few variables such as, the obvious, location but also angle of tilt (slope off horizon), orientation angle, temperature of inlet fluid and also daily ambient temperature. We can calculate the efficiency of collectors for various times throughout the day but given the...

Read more...

Reducing fuel bills and increasing solar thermal output

Q: What is the best way to reduce my fuel bills by incorporating a solar thermal system? A:Reduction +Reduction = Reduction This should come at no surprise to any of our readers but the single best way to save money on energy bills is by reducing your consumption. It is surprising to...

Read more...

Setting your solar thermal system differential temperature setpoint.

Q:What is the most appropriate differential temperature for my solar thermal system? A: The factory setting on our controllers is 12 Degrees. This will work fine but for northern climates it is better to have a delta T of 17 Degrees. This will allow the collector to heat up sufficiently so...

Read more...

SunMaxx Solar Announces New Solar Thermal Logistics Center in Binghamton, NY

SunMaxx Solar announces their new logistics center located in the Binghamton, NY triple cities area near IBM’s original headquarters! The new logistics center will bring added savings and improved deliverer times to all customers located in the Northern states. In 2011, SunMaxx Solar will maintain larger inventory levels of all items...

Read more...