Q:What is the most appropriate differential temperature for my solar thermal system?
A: The factory setting on our controllers is 12 Degrees. This will work fine but for northern climates it is better to have a delta T of 17 Degrees. This will allow the collector to heat up sufficiently so as to not turn the pump on and off early in the cold mornings. In warmer climates, say mid-latitude and below you can keep the factory setting at 12 deg F.
Related Posts
Do I have to run the piping through the roof?
No, you do not have to. You can, and should, use flexible stainless steel piping which allows you to direct... read more
How do I properly size my storage tank for the collector area?
The rule of thumb of 1-3 gallons of storage per ft2 of collector will only get you so far, so it... read more
What type of splice should I use when joining sensor cables to system wiring?
What type of splice should I use when joining sensor cables to system wiring? Do not use wire nuts or connectors.... read more
What is the best angle to position my collectors?
This answer depends on what you are trying to accomplish. For simple Domestic Hot Water systems you should try and... read more
How Do I Determine Sun Angles Throughout the Year For My Location?
How Do I Determine Sun Angles Throughout the Year For My Location?
The University of Oregon provides a free online tool... read more
How do I know if my system is performing the way it should be?
First of all, your system performance will be measured by BTU'S produced, NOT by temperature achieved. The simplest way to... read more
Can I use PEX in a Solar Hot Water System?
Can I use PEX in a Solar Hot Water System? NO!!! PEX will fail in a Solar Hot Water System.... read more
What Is The Difference Between Flat Plates And Evacuated Tube Collectors?
What is the difference between Flat Plates and Evacuated Tube Collectors? While both types of collectors capture the suns energy and... read more
How can I connect an air compressor to my pump station to pressure test my solar thermal system for leaks?
How can I connect an air compressor to my pump station to pressure test my solar thermal system for leaks? Our... read more
Leave a Reply
You must be logged in to post a comment.